Written and maintained by CASRAI Editorial Board
Published · Last updated
On this page
General product and regulatory information only; this page is not legal advice or medical advice.
Short answer
No agency certifies an exam table as "ADA compliant." The reference is the Standards for Accessible Medical Diagnostic Equipment (MDE) at 36 CFR part 1195, issued by the U.S. Access Board. They become mandatory only where an enforcing agency adopts them: the Department of Justice for state and local governments, and HHS for recipients of federal health funding. A table is usually called compliant when it meets those technical criteria, starting with a transfer surface that adjusts from 17 to 25 inches.
Definition and scope
The Access Board’s standards describe how diagnostic equipment must work. They do not say who must buy it. Section M102.1 defines the "enforcing authority" as the entity that adopts the MDE Standards as mandatory requirements, and M201.1 leaves it to that authority to specify the number and type of equipment that must comply (eCFR, 36 CFR part 1195, checked 2026-11-01).
The Department of Justice describes MDE as equipment used in or with medical settings by health care providers for diagnostic purposes, and lists examination tables, examination chairs, weight scales, mammography equipment and x-ray machines as examples (ADA.gov fact sheet, August 8, 2024, checked 2026-11-01). For what an exam table is, its FDA classification and its general height ranges, see the exam table guide; this page covers the accessibility rules and what can be checked against them.
Who must comply, and by when
| Authority | Who it covers | Acquisition rule | Exam table deadline |
|---|---|---|---|
| DOJ, 28 CFR 35.211 (ADA Title II) | State and local government entities, including public hospitals and clinics | MDE purchased, leased or otherwise acquired after October 8, 2024 must meet the Standards for Accessible MDE until the scoping target is met | At least one accessible exam table within two years after August 9, 2024, if the entity uses any exam table |
| HHS, 45 CFR 84.92 (Section 504) | Recipients of HHS federal financial assistance | MDE acquired after July 8, 2024 must meet the Standards until the scoping target is met | At least one accessible exam table within two years after July 8, 2024, if the recipient uses any exam table |
Both rules set the same scoping target: at least 10 percent of the units of each type of equipment in use, and no fewer than one unit. For facilities that specialize in treating conditions that affect mobility, the target is at least 20 percent, and no fewer than one unit. Where a facility has several departments, clinics or specialties, the accessible units must be spread proportionately across them. Both rules also allow equivalent facilitation, with the burden of showing it on the entity, and both include a fundamental-alteration and undue-burden limit (eCFR, 28 CFR 35.211 and 45 CFR 84.92, checked 2026-11-01). The two-year exam table deadlines have now passed.
What the standard measures on an exam table
These are the criteria in 36 CFR part 1195 (checked 2026-11-01) that a table’s specifications can be compared against. Each row is the standard’s own wording or a close paraphrase.
| Criterion | What the standard says | Section |
|---|---|---|
| Transfer height | Surface height measured from the floor to the top of the uncompressed transfer surface. A low position at 17 inches (430 mm), a high position at 25 inches (635 mm), and at least 4 additional positions between them, separated by at least 1 inch (25 mm) | M301.2.1 |
| Transfer supports | Provided for use with the required transfer sides | M302.3.1 |
| Wheelchair space | At least 36 inches (915 mm) wide, with a narrower allowance for spaces on raised platforms | M303.2.2 |
| Standing surface | Where patients stand on the equipment, the surface must be slip resistant | M304.2.1 |
| Lift compatibility | Usable with portable patient lifts | M302.4 |
The 17-inch low position is the figure to check. The HHS rule defines the Standards for Accessible MDE as 36 CFR part 1195 as of January 9, 2017, with the exception of M301.2.2 and M302.2.2, so confirm which edition and exceptions the enforcing agency applies to you.
Where it matters for clinics and supply decisions
- Existing tables. The standards themselves do not address existing diagnostic equipment (M101.3). The DOJ fact sheet says state and local governments do not necessarily have to make all existing MDE accessible, but must still address barriers, for example by using another location or home visits.
- Replacement and additions. New purchases, leases and lease renewals count as acquisitions under both rules until the scoping target is reached.
- Documentation. Because the criteria are numeric, a table’s specification sheet can be read against the rows above, section by section. For the wider room and equipment picture, see the exam room furnishing checklist and the medical supplies for a doctor’s office guide; door and approach dimensions are covered in ADA door width.
Common misunderstandings
- "ADA compliant" is a certification. It is not. The Access Board issues technical standards; the DOJ and HHS rules decide who must use them.
- It applies to every medical office. The DOJ rule covers state and local governments. The HHS rule covers recipients of HHS federal financial assistance. Whether a private practice is covered depends on the rules that apply to it.
- Every table must be accessible. The scoping rules require a share of units (10 or 20 percent, minimum one per equipment type), with the exam table minimum of one.
- The FDA class shows accessibility. FDA classification is a separate regulatory question; it says nothing about whether the Access Board criteria are met.
- Any low-height table qualifies. The standard requires a full adjustable range with at least four intermediate positions, not only a low setting.
Frequently asked questions
Is there such a thing as a certified ADA compliant exam table?
No agency certifies one. The Access Board issues the technical standard in 36 CFR part 1195, and DOJ and HHS rules decide who must use it (eCFR, checked 2026-11-01).
What transfer height range does the standard require?
A low position at 17 inches, a high position at 25 inches, and at least four additional positions between them, at least 1 inch apart (M301.2.1).
Does every exam table in a facility have to meet the standard?
No. Under both the DOJ and HHS rules, at least 10 percent of the units of each equipment type, and no fewer than one, must meet it (20 percent for facilities that specialize in conditions affecting mobility).
Do existing tables have to be replaced?
The standards do not address existing equipment (M101.3), and the DOJ fact sheet says state and local governments do not necessarily have to make all existing equipment accessible, though they must still address barriers.
Sources
All sources checked 2026-11-01.
- U.S. Access Board, Standards for Accessible Medical Diagnostic Equipment, 36 CFR part 1195 (eCFR): https://www.ecfr.gov/current/title-36/part-1195
- U.S. Department of Justice, 28 CFR 35.211, Newly purchased, leased, or otherwise acquired medical diagnostic equipment (eCFR): https://www.ecfr.gov/current/title-28/part-35/section-35.211
- U.S. Department of Health and Human Services, 45 CFR 84.10 and 84.92 (eCFR): https://www.ecfr.gov/current/title-45/part-84/section-84.92
- ADA.gov, Fact Sheet: New Rule on the Accessibility of Medical Diagnostic Equipment Used by State and Local Governments, August 8, 2024: https://www.ada.gov/resources/2024-08-08-mde-fact-sheet/







