Written and maintained by CASRAI Editorial Board
Published · Last updated
On this page
General product information only, not medical advice. Decisions about hearing loss and implants belong with a qualified clinician.
What are the components of a cochlear implant?
A cochlear implant system has an external part worn outside the body and an internal part placed under the skin. The sources describe the parts as a microphone, a speech processor, a transmitter and receiver/stimulator, and an electrode array (NIDCD), or, in one FDA-reviewed system, a stimulator, a magnet-centered coil, electrodes and an external audio processor.
Definition and scope
The FDA describes cochlear implants as electronic hearing devices. The National Institute on Deafness and Other Communication Disorders (NIDCD) says an implant has a portion that sits behind the ear and a second portion that is surgically placed under the skin. This page covers what the parts are called and what each does. It does not describe surgery or outcomes.
Two points of scope matter for anyone reading product literature. First, sources count the parts differently, so the number of “components” depends on who is counting. Second, the FDA states that it does not rate or recommend brands of cochlear implants, so this page names no brand rankings.
How the parts work together
NIDCD gives the sequence in plain terms. The microphone picks up sound from the environment. The speech processor selects and arranges the sounds the microphone picked up. The transmitter and receiver/stimulator receive signals from the speech processor and convert them into electric impulses. The electrode array, a group of electrodes, sends those impulses to different regions of the auditory nerve.
The FDA summary of safety and effectiveness data (SSED) for one manufacturer’s system, MED-EL PMA P000025/S134, adds engineering detail about how the external and internal sides connect. The audio processor analyzes the microphone signal using a programmed speech coding strategy and sends the coded signal to an external coil. The coil is held in place over the implant by a magnet and sends the signal across intact skin through an inductive link. Stimulation energy also travels over that inductive link. In that document the behind-the-ear processor uses an external coil with a magnet of a given strength that is attracted to the magnet inside the implant.
NIDCD also states that an implant does not restore normal hearing; it gives a useful representation of sounds in the environment.
Types of components: a sourced cross-walk
The table lists each part exactly as the named source names it. Rows from the two sources are kept separate on purpose, because they divide the system differently.
| Part as named | What the source says it does or is | Source |
|---|---|---|
| Microphone | Picks up sound from the environment | NIDCD |
| Speech processor | Selects and arranges sounds picked up by the microphone | NIDCD |
| Transmitter and receiver/stimulator | Receive signals from the speech processor and convert them into electric impulses | NIDCD |
| Electrode array | Sends impulses to different regions of the auditory nerve | NIDCD |
| Stimulator (implant) | Part of the implant, listed with a coil containing a magnet, an active electrode, a reference electrode and an electrically evoked compound action potential reference electrode | FDA SSED P000025/S134 |
| External coil with magnet | Held over the implant by magnetic attraction; carries the coded signal across intact skin by an inductive link | FDA SSED P000025/S134 |
| Audio processor (single-unit or behind-the-ear) | Analyzes the microphone signal under the programmed speech coding strategy and sends the coded signal to the coil | FDA SSED P000025/S134 |
| Fitting and programming software and interface | Named in the SSED as part of the system (MAX Programming Interface, HearCare MED-EL) | FDA SSED P000025/S134 |
The rows show why a single parts count cannot be quoted without a source. NIDCD combines the transmitter and receiver/stimulator into one item, while the SSED lists the implant’s stimulator, coil and electrodes separately and also counts the fitting software and interface as part of the system.
External versus implanted parts
The useful distinction is between what sits outside the body and what is implanted. Per NIDCD, one portion sits behind the ear and the other is under the skin. In the SSED system, the processor and its external coil are on the outside, and the stimulator, internal magnet-centered coil and electrodes make up the implant.
Two further points follow from the sources. The programmed speech coding strategy and the fitting software are part of how the processor behaves, so the software interface belongs on a component checklist alongside the hardware. And because the coil is held by magnet attraction to the implant, the SSED treats the magnet strength of the external coil as a variable (“various strengths”), not a fixed detail.
For related reading, see the CASRAI comparisons hearing aid vs cochlear implant and bone-anchored hearing aid vs cochlear implant, the guide on the Osia implant system, and the explainer what is otolaryngology.
Common misunderstandings
It is not a louder hearing aid
The FDA calls cochlear implants electronic hearing devices. NIDCD explains that the electrode array sends electric impulses to different regions of the auditory nerve.
It does not restore normal hearing
NIDCD states that an implant does not restore normal hearing and instead provides a useful representation of sounds.
The FDA does not pick a best brand
Manufacturers must first show the FDA that their implants are safe and effective before selling them in the United States. As a matter of policy, the FDA does not rate or recommend brands.
One manufacturer’s parts list is not every system’s list
The SSED above describes one system. Names and part counts for other systems come from their own FDA records and instructions for use.
FAQ
What are the main components of a cochlear implant?
NIDCD lists a microphone, a speech processor, a transmitter and receiver/stimulator, and an electrode array. An FDA SSED for one system lists a stimulator, a coil with a magnet, electrodes and an external audio processor.
Which parts are outside the body?
NIDCD says one portion sits behind the ear. In the SSED system, the audio processor and its magnet-held external coil are external.
How does the external part connect to the implant?
Through a magnet-held coil and an inductive link across intact skin, which carries both the coded signal and stimulation energy, per the FDA SSED for P000025/S134.
Is software part of the system?
In that SSED, yes: the fitting and programming interface and application are named as part of the system.
Sources
- NIDCD, Cochlear Implants, page last updated June 13, 2024; date checked 2026-10-30.
- U.S. FDA, Cochlear Implants, content current as of 02/03/2022; date checked 2026-10-30.
- U.S. FDA, Summary of Safety and Effectiveness Data, PMA P000025/S134 (MED-EL); date checked 2026-10-30.







