Skip to main content
v2026.11,986 entries · CC-BY 4.0
LAC HealthSponsored

Shop dry ice shipping specimens supplies

  • FDA registered
  • ISO 13485
  • BBB Accredited A+

Shop at LAC Health

Dry Ice Shipping for Medical Specimens: Category B Packaging, Marking and What to Verify

How 49 CFR 173.199 and 173.217 place, vent and mark dry ice in Category B specimen packages, plus what to confirm with the carrier.

Written and maintained by CASRAI Editorial Board

Published · Last updated

On this page

Short answer: for a Category B diagnostic specimen (UN3373), US rules in 49 CFR 173.199 put dry ice outside the secondary packaging or in an overpack, require an outer package that lets carbon dioxide gas escape, and require the package to be marked “Carbon dioxide, solid” or “Dry ice” with an indication that the contents are for diagnostic or treatment use. By air, the net mass of the dry ice must also be marked and the shipper must arrange the shipment with the operator (49 CFR 173.217). Classify the specimen first, then add dry ice as a refrigerant.

General regulatory information for laboratory and clinic staff, not legal, shipping-compliance or medical advice. The sections cited below are the authority.

What counts as dry ice shipping for medical specimens

Dry ice is solid carbon dioxide. When it is only a refrigerant inside a specimen package, two rule sets apply at once: the one for the specimen and the one for the dry ice. Background on the material is in what dry ice is, and the broader UN1845 treatment is in dry ice shipping regulations. This page does not repeat that guide; it covers the sender’s decision order for specimens.

The sections below assume a Category B specimen. If the material might be Category A, see Category A vs Category B and Packing Instruction 620 first, because the specimen category decides which packaging rules apply.

Order of operations: classify first, then add dry ice

Most dry ice fact sheets start with the dry ice. For a specimen the requirements are easier to follow in this order, each tied to the section that states it:

  1. Classify the specimen. Category B (UN3373) is governed by 49 CFR 173.199.
  2. Packaging type. 173.199(a)(1) calls for triple packaging: a primary receptacle, a secondary packaging and a rigid outer packaging. The package must withstand a drop from at least 1.2 m (3.9 ft) with no release into the environment (173.199(a)(4)).
  3. Where the dry ice goes. 173.199(d)(1): ice or dry ice must be placed outside the secondary packaging or in an overpack. The outer packaging must allow carbon dioxide gas to escape, meet 173.217, and contain enough absorbent to take up all liquid, including melt water.
  4. Venting. 173.217(a) requires packaging, when offered by aircraft or water, designed and constructed to permit release of carbon dioxide gas to prevent a buildup of pressure.
  5. Marking. See the checklist below.
  6. Arrangement with the carrier. By air, 173.217(c)(2) says the shipper must make arrangements with the operator for each shipment.

Dry ice shipping regulations for medical specimens: marking checklist

Item What the rule says Source
Specimen category mark “Biological substances, Category B” on the outer packaging, in a diamond whose sides are at least 50 mm with a border of at least 2 mm 49 CFR 173.199(a)(5)
Dry ice name and use Package marked “Carbon dioxide, solid” or “Dry ice”, plus an indication that the contents are for diagnostic or treatment use 49 CFR 173.199(d)(2)
Net mass (air) Net mass of the dry ice marked on the outside of the package 49 CFR 173.217(c)(1)
Weight limits For air, the 173.199 outer-packaging limits (4 L for liquids, 4 kg for solids) do not include ice, dry ice or liquid nitrogen used to maintain the material 49 CFR 173.199(b)(5), (c)(5)

How to ship with dry ice: what the rule requires and what your carrier decides

What the regulation states

For air shipments, dry ice is excepted from the shipping paper requirements of subpart C of part 172; instead the documentation lists the proper shipping name, class 9, UN 1845, the number of packages and the net quantity per package (173.217(c)(4)). Per-package limits in the hazardous materials table columns 9A and 9B do not apply to dry ice used as a refrigerant in a unit load device that is identified to the operator and allows venting (173.217(c)(3)). For other hazardous materials paperwork, see hazmat shipping papers.

What to confirm with the courier or carrier

The regulation leaves acceptance to the operator. A sender can ask each carrier or courier, in writing, about the points the rules above make load-bearing:

  • Will the operator accept the shipment, and how is the arrangement under 173.217(c)(2) recorded?
  • How is the dry ice documentation under 173.217(c)(4) handled for this service?
  • Does the outer packaging allow carbon dioxide to vent, and is there enough absorbent for melt water (173.199(d)(1))?
  • Are the marks in the checklist above in place before hand-over?

Related reading: medical courier services, cold chain shipping for medical supplies and cold chain vendor evaluation.

Common misunderstandings

  • “2.5 kg is always allowed.” Two different 2.5 kg (5.5 lb) rules exist. 49 CFR 173.217(c)(5) excepts up to 2.5 kg per package used to refrigerate contents from other subchapter requirements if the venting rule in (a) is met and the package is properly marked. 49 CFR 175.10(a)(10) is a separate exception for perishables packed in passenger or crew baggage, limited to 2.5 kg per person with operator approval. The baggage rule is not a shipping rule.
  • “Dry ice goes inside the secondary container with the tubes.” For Category B it is placed outside the secondary packaging or in an overpack (173.199(d)(1)).
  • “A sealed, airtight cooler is safest.” The rules require the opposite: the outer packaging must let carbon dioxide gas escape.
  • “The refrigerant counts toward the liquid limit.” Ice, dry ice and liquid nitrogen are excluded from the outer-package limits in 173.199.

Contact with dry ice itself is a separate hazard, covered in what happens if you touch dry ice. Staff who prepare these packages also need hazmat training; see hazmat shipping training for lab staff.

FAQ

What are the dry ice shipping regulations for medical specimens?

For Category B specimens in the US, 49 CFR 173.199(d) and 173.217 govern: dry ice outside the secondary packaging or in an overpack, vented outer packaging, absorbent for melt water, and marking as “Carbon dioxide, solid” or “Dry ice” with a diagnostic or treatment use indication. Air shipments add net-mass marking and operator arrangement.

How do you ship medical specimens with dry ice?

Classify the specimen, use triple packaging for Category B, place the dry ice outside the secondary packaging or in an overpack, allow venting, mark the package, and arrange air shipments with the operator. Carrier acceptance rules apply on top of the regulation.

Is shipping with dry ice the same as shipping the specimen?

No. The specimen category and the dry ice refrigerant are separate regulatory questions; this page answers only the Category B combination.

Sources

Checked 2026-11-01.

Follow CASRAI

Research-administration guidance, standards updates and independent tool reviews.

Ask CASRAI · free to try

Ask about Dry Ice Shipping for Medical Specimens: Category B Packaging, Marking and What to Verify

2 free questions a day, no account.

An AI assistant for research: funder rules, compliance, methods and publishing. It links the sources behind its answers and labels answers that come from a web search.

Answers draw on CASRAI's guides and dictionary plus the federal and funder documents we index: Federal Register, Grants.gov, Regulations.gov and UKRI.

Works on this site and inside Claude, Cursor and the AI tools you already use.

Everything CASRAI publishes — this page, the dictionary, the guides and the news — stays open to read, with no account and no card.

Referenced across the research world

University of Cambridge logoColumbia University logoCrossref logoUniversity of Edinburgh logoHarvard University logoUniversity of Oxford logoPrinceton University logoStanford School of Medicine logoUniversity College London logoORCID logoUniversity of Cambridge logoColumbia University logoCrossref logoUniversity of Edinburgh logoHarvard University logoUniversity of Oxford logoPrinceton University logoStanford School of Medicine logoUniversity College London logoORCID logo
  • University of Cambridge logo
  • Columbia University logo
  • Crossref logo
  • University of Edinburgh logo
  • Harvard University logo
  • University of Oxford logo
  • Princeton University logo
  • Stanford School of Medicine logo
  • University College London logo
  • ORCID logo

View CASRAI adoption →