Skip to main content
v2026.11,986 entries · CC-BY 4.0
LAC HealthSponsored

Shop measure compression stockings supplies

  • FDA registered
  • ISO 13485
  • BBB Accredited A+

Shop at LAC Health

How to Measure for Compression Stockings: Points and Posture

How to measure for compression stockings: morning timing, both legs, bare skin, ankle, calf and thigh points, and why brand charts differ.

Written and maintained by CASRAI Editorial Board

Published · Last updated

On this page

General information only, not medical advice. A clinician, nurse or fitter decides whether compression is suitable and which product and size to use.

Short answer: measure both legs, bare skin, in the morning before swelling builds, and record the circumference at the ankle (and at the calf, or thigh for thigh-high stockings) plus the leg length the manufacturer’s chart asks for. Then match those numbers to that manufacturer’s own size chart, because brands do not all measure at the same points.

This guide is for someone who has been told to wear compression stockings, or who orders them for others, and needs to take usable measurements. For anti-embolism stockings used in hospital, see what TED hose are and how they are measured; for the product category, see what a compression sock is.

What you need

  • A tape measure. Old tapes stretch with time, so check yours is still accurate (Oxford Health NHS Foundation Trust).
  • A sheet of paper for foot length, if the chart asks for it.
  • A pen to mark measuring points on the skin (the SIGVARIS measuring page suggests marking the points).
  • The size chart and measuring diagram of the exact brand and style being ordered.
  • A second person if possible, so the tape stays level and vertical.

How to measure for compression stockings: steps

  1. Choose the time. Measure as early in the morning as possible, before long periods of standing (Oxford Health NHS FT). SIGVARIS likewise advises measuring the leg without swelling, in the morning if possible.
  2. Measure against bare skin. Oxford Health NHS FT states measurements need to be taken next to the skin; an NHS Learning Hub procedure guideline for anti-embolism stockings describes the tape as snug but not tight, against bare skin.
  3. Measure both legs. Oxford Health NHS FT states that when hosiery is needed on each leg, both legs must be measured because they may be different sizes.
  4. Take the ankle circumference. Oxford Health NHS FT notes that manufacturer measurement guides always include ankle circumference. SIGVARIS marks this point (cB) as the narrowest point above the ankle.
  5. Take the calf circumference. Kingston and Richmond NHS FT describes measuring the widest part of the calf. SIGVARIS instead uses a point two finger widths below the hollow of the knee (cD). Use whichever point your brand’s chart specifies.
  6. Take length measurements if the chart asks for them. Kingston and Richmond NHS FT measures foot length; SIGVARIS measures from the floor up to the height of each circumference point (lD, lF). Oxford Health NHS FT advises measuring vertically to the ground rather than following the contours of the body.
  7. For thigh-high stockings, add the thigh. Kingston and Richmond NHS FT measures the thigh when stockings or wraps need to go above the knee; SIGVARIS takes the middle of the thigh (cF) and its floor height (lF).
  8. Write everything down against the correct leg, then read across the manufacturer’s chart.

Posture

Oxford Health NHS FT advises taking measurements standing for thigh-length hosiery, and sitting or standing for calf and ankle. If sitting, the knee is flexed to 90 degrees with the foot on the floor. The NHS Learning Hub anti-embolism guideline, which covers a hospital product, has the patient standing with feet flat.

Measuring points differ between sources

A common shorthand is “ankle narrowest, calf widest”, but the published guidance shows that the exact points are not identical, which is why a generic measurement does not transfer between brands or product types.

Source Product context Calf / knee point Length point
Kingston and Richmond NHS FT patient leaflet Compression treatment Ankle, widest part of the calf, thigh if above-knee Foot length
SIGVARIS measuring page Manufacturer chart cB narrowest above the ankle; cD two finger widths below the hollow of the knee; cF middle of the thigh lD and lF: floor to the height of cD and cF
NHS Learning Hub procedure guideline Anti-embolism stockings Calf at greatest dimension; widest thigh for thigh length Knee length: 1 inch below the knee line to the heel; thigh length: gluteal furrow to heel

Take the practical point: follow the diagram that belongs to the product you are buying, not a diagram from a different brand or a different stocking type.

Off-the-shelf or made-to-measure?

Oxford Health NHS FT describes measuring for off-the-shelf sizes first, with a rule of thumb that they fit about 80% of patients. Made-to-measure is for when the off-the-shelf size does not fit; in that case circumference (c) and length (l) are taken in stages up the limb, measured vertically to the ground.

What can go wrong

  • Measuring when swollen. Swelling later in the day gives larger numbers than the morning leg.
  • Measuring over clothing. Measurements need to be next to the skin.
  • Only measuring one leg. The legs may be different sizes.
  • Using a stretched tape. Old tapes stretch with time.
  • Using the wrong chart. Points differ between sources, as the table shows.
  • Wrong size. In the anti-embolism context, the NHS Learning Hub guideline states incorrect sizing causes swelling and bruising to the ankles and can constrict blood supply.
  • Not re-measuring. Kingston and Richmond NHS FT says you should be measured each time to make sure you get the correct size.

When to get professional help

A nurse, fitter or doctor decides which product and size suit a person, and can take the measurements when you are unsure how, or when the legs are very different in size. Kingston and Richmond NHS FT says torn stockings must be replaced and that old ones may have lost their elasticity; see how long compression stockings last.

FAQ

How do I measure for compression stockings?

Measure both legs against bare skin, ideally in the morning before swelling. Take the ankle and calf circumference (plus thigh circumference and lengths if the chart requires them), then match them to the chart for the specific brand.

What do the numbers and abbreviations on the label or chart mean?

Compression classes depend on the pressure, in mmHg, delivered at the ankle (Oxford Health NHS FT), and British and European standards differ, so check which standard a product states. On SIGVARIS charts, c means circumference and l means length, with letters marking the point: cB at the ankle, cD below the knee, cF mid-thigh, and lD and lF the heights from the floor. Other brands use their own letters. For billing codes see the HCPCS code guide for compression stockings.

Which specification matters most when ordering for a facility?

No single specification outranks the others: Oxford Health NHS FT says the manufacturer’s measurement guide always includes ankle circumference, so the ankle figure is a constant input, and the rest depends on the chart. Record what the chart asks for, per leg, rather than a single “size”.

How do I read a manufacturer spec sheet?

Find the measuring diagram first, then the points it names (for example circumference at the ankle and calf, and a length), and match your recorded figures to each column. Do not mix points from different diagrams. The guide to grading and selection for DVT prophylaxis stockings covers the clinical selection side.

What compatibility questions should I ask before ordering?

  • Is the stocking a hospital anti-embolism type or an ambulatory compression type? The measuring rules above are not interchangeable.
  • Does the chart measure at the same points I measured, and does it need length as well as circumference?
  • Is it thigh-length or knee-length? The thigh is measured only for thigh-length styles.
  • Does the material need to be latex-free? See compression stockings and latex.

Sources

Follow CASRAI

Research-administration guidance, standards updates and independent tool reviews.

Ask CASRAI · free to try

Ask about How to Measure for Compression Stockings: Points and Posture

2 free questions a day, no account.

An AI assistant for research: funder rules, compliance, methods and publishing. It links the sources behind its answers and labels answers that come from a web search.

Answers draw on CASRAI's guides and dictionary plus the federal and funder documents we index: Federal Register, Grants.gov, Regulations.gov and UKRI.

Works on this site and inside Claude, Cursor and the AI tools you already use.

Everything CASRAI publishes — this page, the dictionary, the guides and the news — stays open to read, with no account and no card.

Referenced across the research world

University of Cambridge logoColumbia University logoCrossref logoUniversity of Edinburgh logoHarvard University logoUniversity of Oxford logoPrinceton University logoStanford School of Medicine logoUniversity College London logoORCID logoUniversity of Cambridge logoColumbia University logoCrossref logoUniversity of Edinburgh logoHarvard University logoUniversity of Oxford logoPrinceton University logoStanford School of Medicine logoUniversity College London logoORCID logo
  • University of Cambridge logo
  • Columbia University logo
  • Crossref logo
  • University of Edinburgh logo
  • Harvard University logo
  • University of Oxford logo
  • Princeton University logo
  • Stanford School of Medicine logo
  • University College London logo
  • ORCID logo

View CASRAI adoption →