Written and maintained by CASRAI Editorial Board
Published · Last updated
On this page
General information about color vision tests, not medical advice. Questions about your own vision belong with an eye care professional.
Short answer
The Ishihara test is a set of dot-pattern plates used to screen for red-green color vision deficiency. A person with typical color vision sees a hidden figure in the dots; a person with a red-green deficiency finds it hard or impossible. It is described as a red-green test only. Some programs, such as the Canadian Armed Forces protocol below, pair it with a second test.
What the Ishihara test is
The most common color vision test is a dot plate: the examiner shows a circle made of many differently colored dots, and a shape or number hidden in the pattern is easy to see with typical vision and hard to see with a deficiency (National Eye Institute). The Ishihara Color Plate Test is the best-known example. Its manufacturer-listed full edition has 38 plates, and shorter 8-, 14- and 24-plate versions are sold (Precision Vision product listing).
The same manufacturer describes it as a test for red-green color deficiencies, notes that the existence of a deficiency is usually clear after a few plates, and says the first 24 plates also give an accurate indication of severity.
The National Eye Institute reports that about 1 in 12 men have color vision deficiency, that red-green is the most common type, and that most affected people are born with it. Acquired causes include injury to the retina, optic nerve or brain, retinal detachment, laser injury, certain brain tumors and radiation; acquired loss may worsen with age, often alongside cataracts.
How plate screening is used in practice
Published institutional protocols show how much the test conditions matter. The Canadian Department of National Defence instruction for testing colour vision (a Canadian Armed Forces medical standard, not a universal rule) specifies for the Ishihara plates:
- Lighting: daylight or a True Daylight Illuminator, not direct sunlight.
- Viewing distance of 75 cm, at an angle of 45 degrees.
- About 3 seconds per page, with each eye tested separately.
- Only the first 17 plates are used. Each eye must correctly identify 15 of 17; 3 or more errors on plates 1 to 17 in either eye is a fail.
A different edition or program may set different conditions. The instructions that come with a given plate set, and the protocol of the program using it, govern.
Ishihara plates compared with the Farnsworth D-15 and the CAF combination
The Farnsworth-Munsell Dichotomous D-15 is an abridged version of the 100 Hue Test. Its manufacturer lists it as used for screening color vision defects only, and as identifying red-green and blue-yellow deficiencies. Instead of reading a hidden figure, the person arranges colored caps in order.
| Feature | Ishihara plates | Farnsworth D-15 |
|---|---|---|
| Task | Identify a figure hidden in colored dots | Arrange colored caps in order starting from a fixed cap (CAF protocol) |
| Defect types covered | Red-green (manufacturer) | Red-green and blue-yellow (manufacturer) |
| Stated purpose | Test for red-green deficiencies; severity indication from first 24 plates (manufacturer) | Screening of color vision defects only (manufacturer) |
| CAF administration | Each eye separately, about 3 seconds per plate, first 17 plates | Both eyes together, about 2 minutes, done twice |
| CAF fail rule | 3 or more errors on plates 1 to 17 in either eye | 2 or more major crossing errors; minor errors or a single major crossing pass |
In the CAF instruction the D-15 test is repeated a second time, and if the first two results disagree a third test is done. This is one program’s worked example of combining a plate screen with an arrangement test, not a standard for all settings.
Color blind test types
Two types of in-person color vision test are covered here: plate tests such as Ishihara, where the person reads a figure hidden in dots, and arrangement tests such as the D-15, where the person orders colored caps. Which test fits a program depends on the defect types it must detect, so confirm that a kit’s stated coverage matches the requirement it supports.
Where it matters for clinics and occupational programs
Color vision checks appear in vision, occupational and pre-employment supply planning. A practical checklist:
- Which plate version (8, 14, 24 or 38 plates) does the program’s protocol call for? The CAF protocol, for example, uses the first 17 plates.
- Does the protocol specify lighting, distance, angle and timing, and can the testing space provide them?
- Must the program detect blue-yellow deficiency? If so, the manufacturer describes Ishihara as a red-green test, and the D-15 is listed as covering both.
- Is a second test required when plate results are doubtful or when the program defines a two-test pathway?
For related supply planning, see the optometry clinic supply checklist, the occupational medicine clinic supply checklist and the pre-employment physical exam supply checklist. For background on the specialty, see what is ophthalmology.
Common misunderstandings
- It tests all color vision. The manufacturer describes it as a test for red-green deficiencies; blue-yellow deficiency is outside what it is described as detecting.
- Everyone with a deficiency has the same problem. The National Eye Institute lists red-green, blue-yellow and a rare complete absence of color perception as different types.
- Color vision deficiency always starts at birth. Most cases are inherited, but injury, disease and aging can cause acquired loss.
FAQ
What is the Ishihara test?
A set of dot plates with hidden figures used to screen for red-green color deficiency.
How many plates are in an Ishihara test?
The full test consists of 38 plates, and the same manufacturer sells 8-, 14-, 24- and 38-plate versions.
Can the Ishihara test detect blue-yellow color blindness?
It is described as a test for red-green deficiencies. The D-15 is listed by its manufacturer as identifying both red-green and blue-yellow deficiencies.
What is the Farnsworth D-15?
An abridged version of the 100 Hue Test in which the person arranges colored caps in order; its manufacturer describes it as used for screening only.
What are the types of color vision tests?
Plate tests such as Ishihara and arrangement tests such as the D-15 are the two covered here.
What are Ishihara plates?
The individual numbered pages of dots that make up the Ishihara test.
Sources
- National Eye Institute, Color Blindness, checked 2026-10-30.
- Precision Vision, The Ishihara 14-plate color test (manufacturer listing), checked 2026-10-30.
- Department of National Defence (Canada), Instruction for Testing Colour Vision, checked 2026-10-30.
- Pantone (X-Rite), Farnsworth-Munsell Dichotomous D-15 Color Vision Test (manufacturer listing), checked 2026-10-30.







