Skip to main content
v2026.11,986 entries · CC-BY 4.0
LAC HealthSponsored

Shop order draw blood culture supplies

  • FDA registered
  • ISO 13485
  • BBB Accredited A+

Shop at LAC Health

Order of Draw for Blood Culture: Why Bottles Go First and What to Verify

Blood culture bottles come first in both the CLSI and WHO orders of draw. Compare the two sequences and check what a lab or clinic should confirm locally.

Written and maintained by CASRAI Editorial Board

Published · Last updated

On this page

General information for laboratory and clinic staff, not medical advice and not a collection procedure. Follow your facility’s written protocol and your laboratory’s instructions.

Short answer

In the order of draw, the blood culture bottle comes first. Both the CLSI sequence (published on the CLSI blog, 19 March 2019) and the WHO phlebotomy guideline (2010) list the culture bottle ahead of the coagulation, serum, heparin, EDTA and glycolytic-inhibitor tubes. The reason both give for any fixed order is to avoid carrying additives from one tube into the next.

Definition and scope

The “order of draw” is the sequence in which collection tubes and bottles are filled during one blood collection. This page covers one question inside that sequence: where the blood culture bottle sits, what the two named sources say about it, and what a lab or clinic should confirm locally. The full tube-by-tube sequence is set out in order of draw for venipuncture, and the colour coding in blood draw tube colors. Capillary collection uses a different sequence, covered in capillary order of draw.

These questions are also asked as “blood cultures order of draw”, “order of draw for blood cultures”, “blood culture bottle order of draw” and “order of draw with blood cultures”. They are the same question, and the answer is the same: culture first.

What is the order of draw?

It is a standard sequence that places tubes and bottles in a fixed order so that additives, such as clot activators, anticoagulants and preservatives, do not contaminate the next container. The CLSI list has six positions: (1) blood culture tube or bottle; (2) sodium citrate tube (for example, blue closure); (3) serum tubes, including those with clot activator and gel (for example, red, red-speckled, gold); (4) heparin tubes with or without gel (dark green, light green, speckled green); (5) EDTA tubes with or without gel separator (lavender, pearl, pink); (6) sodium fluoride/potassium oxalate glycolytic inhibitor tubes (gray).

What is the order of draw in phlebotomy?

In phlebotomy practice the order of draw is the written sequence a phlebotomist follows for multi-tube collections. The WHO guideline lists it as a step on drawing samples in the correct order, done to avoid cross-contamination of additives between tubes. WHO adds that colour coding and tube additives may vary, so its recommendations should be verified with local laboratories.

What is the order of draw for a phlebotomist?

For a phlebotomist the practical answer is: the sequence the employing laboratory has adopted, which in both the CLSI and WHO sequences starts with the blood culture bottle. CLSI states that the order is the same whether the specimen is collected by syringe, tube holder or into preevacuated tubes. Where a tube is not on the list, CLSI says its placement should take into account whether its additive could affect the next tube’s results through carryover.

Where culture bottles sit in the CLSI and WHO sequences

Source Culture position What follows Note on cultures
CLSI, “Order of Blood Draw Tubes and Additives” (2019) 1 (“blood culture tube or bottle”) Sodium citrate tube, then serum tubes Only blood culture tubes, glass nonadditive serum tubes, or plastic serum tubes without a clot activator may be collected before the coagulation tube.
WHO, Guidelines on Drawing Blood (2010), Table 2.3 1 (blood culture bottle, yellow-black striped) Coagulation tube (light blue), then serum and clot-activator tubes Used for microbiology: aerobes, anaerobes, fungi. The guideline’s standard alcohol-swab skin step is worded to exclude blood cultures, so cultures have a different preparation route.

The two sequences agree on the position of the culture bottle. They differ in length because they were published at different times: WHO’s Table 2.3 is based on a 2003 United States National Committee for Clinical Laboratory Standards consensus, while the CLSI list dates from 2019 and has six positions. The WHO text does not describe what the different culture preparation involves, so this page does not either.

Why culture comes before additive tubes

Both sources frame the order as additive-carryover control. A blood culture is a microbiology specimen, and the sequence puts it ahead of containers that carry clot activators or anticoagulants. CLSI also notes that plastic serum tubes with a clot activator can interfere with coagulation testing, which is why the permitted tubes before the coagulation tube are limited to cultures, glass nonadditive serum tubes and plastic serum tubes without clot activator.

WHO also lists blood culture contamination rate among the items to monitor. For how contamination is measured and benchmarked, see blood culture contamination rate.

Checklist for labs and clinics before a draw station is stocked

This checklist is drawn only from the two sources listed at the end of this page.

  • Written local sequence. WHO says to verify recommendations with local laboratories. Confirm that the station’s posted sequence matches the laboratory’s own, including where culture bottles go.
  • Colour codes and additives. WHO notes that colour coding and tube additives may vary, so check each tube type on the station against the sequence rather than relying on colour alone.
  • Tubes not on the list. CLSI says their placement should consider whether the additive could affect the next tube’s results through carryover.
  • Collection method. CLSI states the order is the same for syringe, tube holder and preevacuated tubes, so one sequence should cover every method used at the station.
  • Culture bottle identity. Confirm with the laboratory which culture bottles and kit contents it uses, since the sources identify the position of the bottle but not a specific product.

A broader station checklist is in phlebotomy lab supply checklist.

Common misunderstandings

  • “Charts disagree, so one is wrong.” Charts differ in length and tube names because they come from different editions and sources; the culture bottle is first in both the CLSI and WHO sequences.
  • “Colour tells you the position.” WHO states colour coding and additives may vary. The position follows from the tube’s contents.
  • “Cultures follow the same skin step as every other tube.” WHO’s standard alcohol-swab step is worded to exclude blood cultures.
  • “The order changes with the collection method.” CLSI says it does not change between syringe, tube holder and preevacuated tubes.

FAQ

What is the order of draw?

A fixed sequence of tubes and bottles that limits additive carryover between containers. In the CLSI list the first position is the blood culture tube or bottle, followed by sodium citrate, serum, heparin, EDTA and glycolytic-inhibitor tubes.

What is the order of draw in phlebotomy?

The same sequence applied during a multi-tube collection. WHO describes this as drawing samples in the correct order and tells staff to verify the recommendations with their local laboratory.

What is the order of draw for a phlebotomist?

The laboratory’s adopted sequence. In the CLSI and WHO sources it begins with the blood culture bottle and is the same for syringe, tube holder and preevacuated tubes (CLSI).

Where does the blood culture bottle go in the order of draw?

First, in both the CLSI (2019) and WHO (2010) sequences.

Sources

  • CLSI, “Order of Blood Draw Tubes and Additives”, CLSI Insights blog, 19 March 2019, clsi.org. Checked 2026-11-04.
  • World Health Organization, WHO Guidelines on Drawing Blood: Best Practices in Phlebotomy, 2010 (step 8, step 5 and Table 2.3), CDC Stacks record. Checked 2026-11-04.

Follow CASRAI

Research-administration guidance, standards updates and independent tool reviews.

Ask CASRAI · free to try

Ask about Order of Draw for Blood Culture: Why Bottles Go First and What to Verify

2 free questions a day, no account.

An AI assistant for research: funder rules, compliance, methods and publishing. It links the sources behind its answers and labels answers that come from a web search.

Answers draw on CASRAI's guides and dictionary plus the federal and funder documents we index: Federal Register, Grants.gov, Regulations.gov and UKRI.

Works on this site and inside Claude, Cursor and the AI tools you already use.

Everything CASRAI publishes — this page, the dictionary, the guides and the news — stays open to read, with no account and no card.

Referenced across the research world

University of Cambridge logoColumbia University logoCrossref logoUniversity of Edinburgh logoHarvard University logoUniversity of Oxford logoPrinceton University logoStanford School of Medicine logoUniversity College London logoORCID logoUniversity of Cambridge logoColumbia University logoCrossref logoUniversity of Edinburgh logoHarvard University logoUniversity of Oxford logoPrinceton University logoStanford School of Medicine logoUniversity College London logoORCID logo
  • University of Cambridge logo
  • Columbia University logo
  • Crossref logo
  • University of Edinburgh logo
  • Harvard University logo
  • University of Oxford logo
  • Princeton University logo
  • Stanford School of Medicine logo
  • University College London logo
  • ORCID logo

View CASRAI adoption →