Skip to main content
v2026.11,986 entries · CC-BY 4.0
LAC HealthSponsored

Shop woods lamp supplies

  • FDA registered
  • ISO 13485
  • BBB Accredited A+

Shop at LAC Health

Wood’s Lamp: What It Is, Types and What the Colors Mean

What a Wood’s lamp is, how a true 365 nm lamp differs from a blacklight, what glow colors a review reports, and why results can mislead.

Written and maintained by CASRAI Editorial Board

Published · Last updated

This page describes products and general use; it is not medical advice.

On this page

A Wood’s lamp is a handheld ultraviolet (UV-A) light, used in a darkened room, that makes some skin and hair conditions, microorganisms and substances glow in recognizable colors. This guide explains what the device is, how a true Wood’s lamp differs from an ordinary blacklight, which glow colors a peer-reviewed review reports, and why a result can be misleading.

What is a Wood’s lamp?

A Wood’s lamp is a UV light source that emits long-wave ultraviolet radiation, roughly 320 to 400 nm, with a peak at 365 nm, through a filter that blocks most visible light. A 2022 review in the Journal of Clinical and Aesthetic Dermatology calls it a time-tested tool that aids in diagnosing certain superficial infections, pigmentary disorders and metabolic diseases (Dyer and Foy, 2022).

Who uses it: clinicians in dermatology, and clinic staff who set up and maintain the device. A 2025 review in Sensors also covers dental photodiagnostics (Kwasny, Stachnio and Bombalska, 2025). The lamp is an aid for a trained observer; it does not by itself diagnose anything.

The device is named for Robert Wood, who invented it in 1903; its first dermatology use, in 1925, was for fungal hair infections (Kwasny et al., 2025).

How it works and how it is built

The classic lamp was a mercury vapor lamp fitted with a filter made of barium silicate glass. That filter is barium silicate with 9% nickel oxide, and it blocks most of the visible spectrum while letting UV through. Because the classic design had low radiation power density, tests had to be done in a heavily darkened room (Kwasny et al., 2025; Dyer and Foy, 2022).

Modern Wood’s lamps are built from a matrix of light-emitting diodes (LEDs) with a peak near 365 nm (Kwasny et al., 2025). When the UV strikes certain compounds in skin, hair or on the surface, they absorb it and re-emit visible light. That glow is the fluorescence the observer reads.

Types and variants: Wood’s lamp, LED lamp and blacklight

Not every UV light is a Wood’s lamp. The table below compares the light sources.

Type Typical use Key difference Source
Traditional Wood’s lamp (mercury vapor with Wood’s glass filter) Dermatologic fluorescence examination Peak at 365 nm; barium silicate filter with 9% nickel oxide blocks most visible light; low power density, so a heavily darkened room is needed Dyer and Foy 2022; Kwasny et al. 2025
Modern LED Wood’s lamp Dermatologic and dental photodiagnostics Matrix of LEDs with a peak near 365 nm instead of a mercury lamp Kwasny et al. 2025
Ordinary blacklight (LED, fluorescent or blue bulb) Alternative to a Wood’s lamp Peaks at 375, 385 or 395 nm and produces less fluorescence; fluorescence can differ from a true Wood’s lamp Dyer and Foy 2022
Smartphone blue screen at maximum brightness Option in resource-poor settings The review states a Wood’s lamp is always the superior option Dyer and Foy 2022

The review also notes that a Wood’s lamp magnifies about 1.5 times, which conventional blacklights do not (Dyer and Foy, 2022).

What distinguishes one UV light from another?

A Wood’s lamp is described by its 365 nm peak, its visible-light filter and its roughly 1.5 times magnification. Fluorescence from other UV sources can differ, so findings recorded with one source should not be assumed to match another source’s. Dimensions vary by model and are set by the manufacturer, so check the product’s labeling and instructions for use.

What do the glow colors mean?

The table lists fluorescence reported in the 2022 review. These are observations made in a clinical setting by trained staff, not a way to identify a condition.

Finding Reported glow
Pseudomonas infection Green
Erythrasma (coproporphyrin III) Coral red
Trichomycosis axillaris Pale yellow
Cutibacterium acnes in follicles Orange-red
Microsporum species (scalp fungal infection) Blue-green
Tinea versicolor Yellow-orange
Vitiligo Bright blue-white
Melasma Epidermal type brown or black; dermal type grey-blue
Milia Bright yellow
Porphyria cutanea tarda (urine) Pink to orange-red

Source: Dyer and Foy, 2022 (checked 2026-10-30).

Eye safety and handling

  • Fluorescence is read in a darkened room, because the glow is faint next to ordinary light.
  • Eyes: ophthalmologists reported no harmful effects on superficial eye structures, but the review recommends UV protective goggles in pediatric dermatology, and notes chronic exposure may contribute to cataract formation and ocular aging.
  • Follow the manufacturer’s instructions for use for the specific device.

Source: Dyer and Foy, 2022. For general eye-protection background see what safety goggles are and lab PPE.

Limits: false positives and false negatives

  • Substances on the skin. The review lists highlighter ink, dried soap and laundry detergents with optical brighteners, lint, cosmetics, certain sunscreens and ointments, hair dyes and wet ear wax among sources of false positives. The 2025 review also names cosmetics and sunscreens.
  • A dark result is not proof of absence. Tinea capitis caused by Trichophyton tonsurans does not fluoresce, and the review states that a negative Wood’s lamp test does not rule it out. The lamp has limited usefulness for onychomycosis.
  • Not every lesion glows. In tinea versicolor only about one-third of lesions fluoresce, and cutaneous melasma does not fluoresce (Kwasny et al., 2025).
  • Blacklight versus Wood’s lamp. A 375, 385 or 395 nm source can give different fluorescence than a 365 nm Wood’s lamp.

Source: Dyer and Foy, 2022; Kwasny et al., 2025. For related equipment, see the dermatology office supply checklist; for the physics of emitted light, see fluorescence spectroscopy.

FAQ

What is a Wood’s lamp?

A Wood’s lamp is a handheld UV-A light with a peak near 365 nm and a filter that removes most visible light. Used in a dark room, it makes certain skin and hair findings fluoresce in characteristic colors, which a clinician interprets alongside other information.

Is a Wood’s lamp the same as a blacklight?

No. Ordinary blacklights can peak at 375, 385 or 395 nm and produce less fluorescence, and the review says their fluorescence can differ from a true Wood’s lamp. A Wood’s lamp also magnifies about 1.5 times (Dyer and Foy, 2022).

Is a Wood’s lamp safe for the eyes?

Ophthalmologists reported no harmful effects on superficial eye structures, yet UV protective goggles are recommended in pediatric dermatology and chronic exposure may cause cataract formation (Dyer and Foy, 2022). Follow the device’s instructions for use.

Does every condition glow under a Wood’s lamp?

No. Some organisms, such as Trichophyton tonsurans, do not fluoresce, and the review states a negative test does not rule out that infection (Dyer and Foy, 2022).

Sources

Follow CASRAI

Research-administration guidance, standards updates and independent tool reviews.

Ask CASRAI · free to try

Ask about Wood’s Lamp: What It Is, Types and What the Colors Mean

2 free questions a day, no account.

An AI assistant for research: funder rules, compliance, methods and publishing. It links the sources behind its answers and labels answers that come from a web search.

Answers draw on CASRAI's guides and dictionary plus the federal and funder documents we index: Federal Register, Grants.gov, Regulations.gov and UKRI.

Works on this site and inside Claude, Cursor and the AI tools you already use.

Everything CASRAI publishes — this page, the dictionary, the guides and the news — stays open to read, with no account and no card.

Referenced across the research world

University of Cambridge logoColumbia University logoCrossref logoUniversity of Edinburgh logoHarvard University logoUniversity of Oxford logoPrinceton University logoStanford School of Medicine logoUniversity College London logoORCID logoUniversity of Cambridge logoColumbia University logoCrossref logoUniversity of Edinburgh logoHarvard University logoUniversity of Oxford logoPrinceton University logoStanford School of Medicine logoUniversity College London logoORCID logo
  • University of Cambridge logo
  • Columbia University logo
  • Crossref logo
  • University of Edinburgh logo
  • Harvard University logo
  • University of Oxford logo
  • Princeton University logo
  • Stanford School of Medicine logo
  • University College London logo
  • ORCID logo

View CASRAI adoption →