Written and maintained by CASRAI Editorial Board
Published · Last updated
On this page
Short answer: to use a wrist blood pressure monitor, rest seated for a few minutes, put the cuff snugly on your bare wrist, support your elbow so the monitor sits at the same height as your heart, stay still and quiet, and press start. Details such as how to hold the wrist differ by model, so your own instructions for use (IFU) decide.
This page covers general device use only. It is not medical advice and does not tell you what a reading means. Ask a clinician or pharmacist about your own readings and about which type of monitor suits you.
This guide is for someone who has a wrist monitor in hand and wants consistent readings. It covers the steps, the posture mistakes that manufacturers list as causes of error, and which details vary between models. It does not repeat how monitors are validated, how they are cleared by the FDA, or how cuffs are sized; those are covered in validated blood pressure monitors, FDA-approved blood pressure monitors and what a blood pressure cuff is.
What you need
- A wrist blood pressure monitor and its printed or online instructions for use.
- A chair with back support and a table, cushion or armrest that lets you rest your elbow so the wrist can reach heart level. Omron suggests a cushion or armrest to support the elbow; Panasonic’s manual says to rest your elbows on a table or other level surface.
- Bare skin on the wrist. Omron describes the cuff as wrapped snugly, but not too tight, around the bare wrist.
- Working batteries or power, as your manual directs.
Steps
- Read your manual first. Posture and procedure differ between models, as the table below shows.
- Sit and rest. Sit in a chair with your feet flat on the floor. Omron says to relax for 5 minutes; Panasonic’s manual says to rest for about four to five minutes.
- Fit the cuff. Wrap it snugly, not too tight, around the bare wrist, with the display on the inside of the wrist facing you. Omron says to place it about 1–2 cm from the base of the palm.
- Bring the wrist to heart level. Both manufacturers say the monitor or cuff must be at the same height as the heart. Support your elbow on a table, cushion or armrest rather than holding the arm up with effort.
- Position the hand as your manual says. See the table below: the two sources read differently on whether to keep the wrist straight or slightly bent.
- Stay still. Take a deep breath, remain still, and do not talk (Omron and Panasonic). Panasonic also says not to move the body, arm or fingers.
- Start the measurement and keep the position until the monitor finishes and shows the result.
Details that differ by source
| Detail | What each source says |
|---|---|
| Wrist posture | Omron (Asia-Pacific guidance on its wrist monitors): even slight bending of the wrist can throw off the numbers. Panasonic EW3037 manual: “Slightly bend your wrist.” These conflict, so follow the IFU for your exact model. |
| Rest before measuring | Omron: 5 minutes. Panasonic EW3037: about four to five minutes. |
| Height of the cuff | Omron and Panasonic agree: heart level. |
What can go wrong
- Wrist too high or too low. Omron says this can make readings higher or lower than your actual blood pressure.
- Wrist bent the wrong way or tense. Panasonic’s manual lists a wrist bent inwards, a tense wrist or fist, and leaning forward as conditions that cause a failed or wrong measurement.
- Moving or talking during the measurement (Panasonic; Omron asks you to remain still).
- Interference. Panasonic’s manual says not to use the monitor close to cellular phones or devices that emit electromagnetic waves.
- Skipping the IFU. Posture and procedure vary by model, as the table shows. Servicing and calibration also follow the manufacturer; see calibration of a blood pressure monitor.
When to get professional help
A wrist monitor measures; it does not interpret. Ask a doctor, nurse or pharmacist what your readings mean and whether a wrist monitor is suitable for you. If the monitor gives errors repeatedly even when you follow the steps, contact the manufacturer. For coverage questions about a home monitor, see blood pressure monitor HCPCS code. If you feel unwell or are worried about a reading, contact a clinician or local emergency services rather than relying on the device.
FAQ
Should the wrist be at heart level?
Yes. Omron says the wrist must be at the same level as the heart, and Panasonic’s manual says the pressure cuff must be at heart level. Resting the elbow on a table, cushion or armrest helps.
How long should I rest first?
Omron says 5 minutes and Panasonic’s EW3037 manual says about four to five minutes. Use the figure in your own manual.
Should I keep my wrist straight or slightly bent?
It depends on the model. Omron says slight bending can throw off numbers; Panasonic’s EW3037 manual says to slightly bend the wrist. Follow the manual for your exact device.
Can I talk or move during a measurement?
No. Omron asks you to remain still, and Panasonic’s manual says not to talk and not to move your body, arm or fingers while measuring.
Sources
- Omron Healthcare Asia-Pacific, “How to Ensure Accurate Measurements with OMRON Wrist Blood Pressure Monitors”: https://www.omronhealthcare-ap.com/healthblog/en/Article/Detail/171-How-to-Ensure-Accurate-Measurements-with-OMRON-Wrist-Blood-Pressure-Monitors- (checked 2026-11-01).
- Panasonic EW3037 wrist blood pressure monitor user manual: https://personalcare.manualsonline.com/manuals/mfg/panasonic/ew3037_1.html?p=8 (checked 2026-11-01).







