Written and maintained by CASRAI Editorial Board
Published
On this page
There is no universal length for a literature review. The right length is set by the document it sits in: a thesis handbook, a journal’s author guidelines, or a funder’s call. Where no rule exists, published guidance gives ranges that depend on the level of study. One UK university guide puts a PhD literature review chapter at roughly 8,000 to 10,000 words, a Master’s dissertation review at around 2,000 to 3,000 words, and an undergraduate review at no more than about 2,000 words.
This page is for students and early-career researchers who need to decide how many words to give a literature review, and how to find the number that actually binds them. It does not give a single figure, because the sources do not support one.
Purpose of the section: why length follows function
A literature review shows the breadth of your reading, introduces the topic and its background, and identifies the gap your own work addresses. The West Virginia University Health Sciences Center thesis guidelines describe it as an in-depth critique rather than a catalogue of facts. Length is a consequence of that job: the review needs enough space to analyse the sources that bear on your question, and no more. See the layout of a literature review for how to organise it, and the literature review template for a skeleton to fill.
How long is a literature review? Ranges by level of study
The only quantified ranges we cite come from a single source, the University of Kent guide “Literature Reviews” (a UK university guide, read 2026-11-08). They are one institution’s guidance, not a norm across universities.
| Level | Typical length in the Kent guide |
|---|---|
| PhD thesis (usually one chapter) | perhaps 8,000 to 10,000 words |
| Master’s dissertation | around 2,000 to 3,000 words |
| Undergraduate dissertation | no more than about 2,000 words |
The same guide stresses that the word count can vary with the length of the dissertation, the nature of the subject and the level of study, and that if in doubt you should ask your supervisor.
It also offers a rough relationship between dissertation length and the number of sources: about 8 to 10 significant pieces of work for an 8,000-word dissertation, and up to about 20 major works for a dissertation of 12,000 to 15,000 words.
When the guidance says there is no fixed length
The West Virginia University Health Sciences Center guidelines for theses and dissertations (2016, read 2026-11-08) say: “There are no strong guidelines for length of the literature review and the student should discuss expectations with both his/her advisor and advisory committee.” Treat that as the honest default for a thesis chapter: the number is agreed with the people who will examine it.
Structure: how to find the number that binds you
- Check the governing document first. For a thesis, that is the institution’s thesis handbook or graduate school guidelines. For a journal article, it is the journal’s author guidelines and any overall word limit. For a proposal, it is the call or the funder’s instructions (see how long a research proposal should be).
- Ask your supervisor or committee. Both sources above direct students to do this where the written rule is silent.
- Work out the whole-document budget. If the document has an overall word limit, allocate the review a share. Any percentage you choose is an editorial heuristic of your own, not a published standard; confirm it with your supervisor.
- Let the source count and the argument size it. The Kent guide suggests using most of the word limit to analyse sources rather than describe them, so the number of sources you can treat properly limits the length you can justify.
- Draft, then cut or expand. Write to the argument, then trim or extend to fit the limit.
How long is a literature review in a thesis, an article or a proposal?
A thesis review is usually a chapter (see the Kent ranges above); an article review is normally part of the introduction and shares the article’s overall limit, so check the journal’s guidelines (the introduction section guide covers where it fits); a proposal review is sized by the call. We found no source that gives one number across these three document types, so none is given here.
A short worked example: illustrative arithmetic, not a norm
The numbers below are an illustrative planning exercise, not figures from any institution. Suppose your handbook gives a review chapter an allowance of 9,000 words and you have 30 sources that bear directly on your question. Dividing evenly gives about 300 words per source, but that is the wrong way to spend them: if a few central works need 400 to 600 words of analysis each, the minor ones should be grouped and handled together in a sentence or two. The exercise shows why the source count and the argument, not a percentage, should drive the length.
An annotated sentence pair shows the difference between summary and synthesis (invented placeholder authors, for illustration only):
- Summary: “Author A (year) studied X. Author B (year) studied Y.” (Two sources, no relationship stated; uses words and adds little.)
- Synthesis: “Studies of X and Y reach different conclusions about Z, a difference that appears to follow from how each defines Z.” (One sentence covers both sources and states the point.)
The UNC Writing Center’s literature review guidance draws the same summary versus synthesis distinction and describes thematic, chronological and methodological organising patterns (cached source, last verified 2026-07-17).
Common mistakes about length
- Applying a figure found in a blog post or from another university instead of your own handbook.
- Spending the word count describing sources one by one rather than analysing them against each other.
- Treating the number of references as the measure, rather than how well each is used.
- Padding with background that belongs in the introduction.
- Not asking: both cited sources say to consult the supervisor or committee.
Checklist
- I have read the handbook, author guidelines or call that states a word limit.
- I have asked my supervisor or committee where the document is silent.
- The review analyses and compares sources rather than listing them.
- It leads clearly to the gap my own work addresses.
- Material that belongs elsewhere (formatting, such as an APA literature review sample) is handled in its own place.
Frequently asked questions
How long should a literature review be?
It depends on the document and level. One UK university guide gives about 8,000 to 10,000 words for a PhD chapter, 2,000 to 3,000 for a Master’s dissertation and up to about 2,000 for an undergraduate dissertation; always confirm with your supervisor and your own handbook.
How long is a literature review in a PhD thesis?
The Kent guide says perhaps 8,000 to 10,000 words as one chapter. West Virginia University’s health sciences guidelines say there are no strong guidelines and the length should be agreed with the advisor and committee.
Is there a percentage of the dissertation the review should take up?
The sources we cite give no percentage rule. Any proportion is an editorial heuristic to be checked against your handbook and supervisor.
How many sources does a literature review need?
The Kent guide gives a rough guide of 8 to 10 significant pieces for an 8,000-word dissertation and up to about 20 major works for 12,000 to 15,000 words. It is guidance from one institution, not a requirement.
Sources
- University of Kent, “Literature Reviews” guide: media.www.kent.ac.uk/se/52777/LiteratureReviews.docx (read 2026-11-08).
- West Virginia University Health Sciences Center, “Guidelines for Preparation of Theses and Dissertations” (2016): hsc.wvu.edu guidelines PDF (read 2026-11-08).
- UNC Writing Center, “Literature Reviews” (verified 2026-07-17).







