Written and maintained by CASRAI Editorial Board
Published · Last updated
On this page
General product information, not safety advice. Follow your institution’s PPE requirements and the supplier’s own labelling.
There is no industry-standard lab coat size chart. Each brand and supplier publishes its own, so a size M from one supplier can differ from a size M from another. The chart below is one real supplier’s chart, shown as a worked example of what a lab coat size table contains, followed by the measuring methods that suppliers and a university guide publish.
Lab coat size chart: one supplier’s example (cm)
This is the unisex lab coat with cuffs chart from the University of Otago online shop, checked on 2026-10-30. Values are the garment dimensions the shop lists, in centimetres. The shop notes that sizes may differ by 1 to 2 centimetres due to different fabrics and design.
| Size | Chest | Length (from shoulder point) | Shoulder (seam to seam) | Armhole (straight) | Sleeve (from point) |
|---|---|---|---|---|---|
| 3XS | 88 | 87 | 35.5 | 22 | 53 |
| 2XS | 94 | 88 | 38 | 22 | 54 |
| XS | 100 | 89 | 40.5 | 23 | 55 |
| S | 106 | 91 | 43 | 24 | 56 |
| M | 112 | 92 | 45.5 | 25 | 57 |
| L | 118 | 94 | 48 | 25 | 58 |
| XL | 124 | 96 | 50.5 | 26 | 58 |
| 2XL | 130 | 97 | 53 | 27 | 59 |
| 3XL | 136 | 98 | 55.5 | 28 | 61 |
| 4XL | 142 | 100 | 58 | 29 | 62 |
| 5XL | 148 | 101 | 60.5 | 30 | 63 |
| 6XL | 154 | 103 | 63 | 31 | 64 |
| 7XL | 160 | 104.5 | 65.5 | 32 | 65 |
Check your product’s labelling: use the chart that belongs to the exact coat you are ordering, not this table.
How to read a lab coat size chart
Start by checking what the numbers describe. The Otago chart above lists garment dimensions, meaning measurements of the coat itself. Genius Lab Gear’s size finder, by contrast, asks you to take body measurements of your chest, waist and hips and compare them with its chart. Comparing a body measurement to a garment-dimension column, or the reverse, is an easy way to pick the wrong size.
Chest is the key column. The University of Nottingham’s lab coat sizing guide describes chest as among the most important measurements because it determines the jacket size and is hard to alter later.
How to measure for a lab coat
Use a flexible tape measure and wear what you would normally wear under the coat. These steps come from the Genius Lab Gear size finder and the Nottingham guide.
- Chest: measure the widest part of the chest, directly under the armpits, with a big inhale (Genius Lab Gear). Nottingham describes running the tape under the armpits and around the shoulder blades, the widest part of the torso.
- Waist: at the natural waistline, about 6 to 8 inches below the armpits (Genius Lab Gear).
- Hips: at the widest point, with feet shoulder-width apart (Genius Lab Gear).
- Tape tension: use a soft tape and do not pull it tight (Genius Lab Gear).
Genius Lab Gear’s rule is to pick the smallest size where all three measurements are at or below the numbers in its chart. When you fall between sizes, it recommends sizing up for a roomier fit. For women’s coats, Nottingham suggests using your dress size, and advises wrapping the tape loosely under the armpits, over the shoulder blades and across the front of the chest, and measuring the hips too. Genius Lab Gear adds that for a maternity coat the choice is made mainly by bust.
Converting between sizing systems
Chest in inches, centimetres and suit sizes
One inch is 2.54 centimetres, so inch and centimetre charts can be converted directly. Brand conventions cannot. Nottingham explains that men’s lab coats are usually sized in line with suit-jacket measurements, so the size inside the tag of a well-fitting suit jacket is a starting point. Its example: a 38 inch chest corresponds to a size 38 coat.
S, M, L versus measurements
Letter sizes carry no fixed measurement. Nottingham states that sizes can vary from one brand to the next, and Otago’s own note about 1 to 2 centimetre differences shows tolerance even within one product. Always go back to the supplier’s measurements for the coat in front of you.
Common mix-ups
- Garment versus body dimensions. Confirm which one a chart lists before comparing your tape reading.
- Assuming one brand’s size equals another’s. Nottingham states that sizes can vary from one brand to the next.
- Ignoring belts. Genius Lab Gear says a built-in belt can pull the waist in by up to 8 inches, so a belted style fits differently at the waist.
- Forgetting shrinkage. Genius Lab Gear says hot washing and drying can shrink a coat about 3%, roughly half a size.
- Measuring over the wrong clothing. Genius Lab Gear advises wearing what you would normally wear under the coat when you measure.
Frequently asked questions
How do you choose a lab coat?
Measure your chest (and waist and hips if the supplier’s chart uses them) with a flexible tape over the clothing you would wear under the coat, then compare to the chart for that exact coat. Chest drives the fit most (Nottingham). For the materials and types of coat, see what a lab coat is and the common types.
How should a lab coat fit and how do you wear one?
Suppliers address fit through measurements: choose the size where your chest, waist and hip measurements fit the chart, and size up if you are between sizes and want a roomier fit (Genius Lab Gear). Closure, wearing and care are covered in the lab coat guide.
What is a lab coat?
A lab coat is a protective garment worn over everyday clothing in laboratories. Types, fabrics and limits are explained in the plain-language lab coat guide, and wider protective equipment in what lab PPE is.
Are lab coat sizes the same as scrub or glove sizes?
Each garment type has its own sizing. For scrubs see scrub sizes; for gloves see nitrile glove sizing. Medical apparel is listed by category at lac.us.
Sources
- University of Otago online shop, unisex lab coat with cuffs: onlineshop.otago.ac.nz (checked 2026-10-30).
- Genius Lab Gear, Lab Coat Size Finder: geniuslabgear.com (checked 2026-10-30).
- University of Nottingham, How to Size Men’s or Unisex Lab Coats (PDF): nottingham.ac.uk (checked 2026-10-30).







