Written and maintained by CASRAI Editorial Board
Published · Last updated
On this page
Short answer
The NIST Center for Neutron Research (NCNR) is a national user facility at the National Institute of Standards and Technology in Gaithersburg, Maryland. It runs a research reactor and a set of neutron instruments, and it gives qualified academic, industrial and government researchers access to them through a peer-reviewed beam-time process. Its stated mission is to advance economic and technical excellence in the U.S. by providing world-class neutron measurement capabilities.
Definition and scope
NIST describes the NCNR as a national user facility offering thermal and cold neutron beam instrumentation for use by all qualified applicants (NIST, About the NCNR, page updated 31 October 2024, read 13 November 2026). The users come from industry, academia and government. The facility is part of NIST rather than a university or a Department of Energy laboratory, which matters when you are looking for the right access rules: NCNR beam time is allocated through NCNR’s own process, not through a different facility’s portal.
The NCNR home page, as displayed on 13 November 2026, lists 29 instruments, more than 300 publications per year and more than 2,000 research participants per year. Treat those as NIST’s own banner figures on that date, not fixed values; they change as the page is updated.
Neutrons are used to probe the structure and dynamics of materials. For background on the discipline that most users come from, see what is materials science and what is crystallography.
The reactor behind the facility
The neutrons come from the NIST research reactor, known as the NBSR. According to the NCNR reactor overview (read 13 November 2026), the NBSR is a high-performance research reactor rated at 20 MW, moderated and cooled by heavy water.
The same page records a regulatory detail that general summaries usually leave out. Under License Amendment No. 17, the reactor is officially classified as a "Research Reactor", replacing the earlier "testing facility" classification. It operates under U.S. Nuclear Regulatory Commission License No. TR-5 (Docket 50-184), which NIST describes as non-expiring, and it follows a five-year safety analysis update cycle instead of 20-year renewals.
A planned replacement: the NIST Neutron Source
NIST Technical Note 2280 (Cook, Majkrzak, King and Neumann; approved 21 December 2023) presents a pre-conceptual design for a replacement reactor called the NIST Neutron Source (NNS). It is a design study, not a built facility. The table below sets the operating NBSR against the design described in that report, using only values the two NIST sources state.
| Feature | NBSR (operating) | NNS (pre-conceptual design) |
|---|---|---|
| Power | 20 MW | Planned 20 MW |
| Coolant and moderator | Heavy water (D2O) | Light water (H2O), pool-type compact core |
| Fuel | Not stated on the reactor overview page | High-assay low-enriched U-10Mo; nine fuel assemblies in a 3×3 lattice |
| Cold neutron sources | Not stated on the reactor overview page | Two liquid-deuterium (LD2) cold sources in a D2O reflector tank |
| Status | Licensed research reactor, NRC License TR-5 | Design report; not a licensed or constructed facility |
The report also notes that the only cold neutron instrument in the reactor hall at the time of writing is MACS, which sits on its own dedicated liquid-hydrogen cold source.
How access works in practice
Access is governed by the NCNR’s "Obtaining Beam Time" page (read 13 November 2026). Proposals are normally peer-reviewed, first by technical experts on the scientific topic. The NCNR Beam Time Allocation Committee then recommends instrument time, and NCNR staff schedule the approved time. Calls for proposals are issued approximately twice a year; check NIST’s page for the current call, because the dates change.
The page describes more than one way in, summarised in the data table below. In short:
- General proposal. A researcher submits a proposal that goes through the peer review and allocation steps above.
- Working with staff. The page invites would-be users to contact a staff member to discuss their ideas before proposing.
- Consortium instruments. Some instruments, such as the NG7 30-m SANS and the BT2 Imaging Facility, are consortium instruments, and consortium members are entitled to a portion of the time.
- Proprietary access. Users who want proprietary access are directed to contact the relevant Team Leads.
A planning checklist drawn from the access page
- Identify which NCNR instrument your measurement needs, and whether it is a consortium instrument such as NG7 30-m SANS or BT2, where consortium members hold a portion of the time.
- Contact an NCNR staff member to discuss the idea; the page explicitly invites this.
- Find the current call for proposals on the NIST page, since calls are issued approximately twice a year.
- Expect peer review by technical experts, then a recommendation by the Beam Time Allocation Committee, then scheduling by staff.
- If the work is proprietary, contact the relevant Team Leads instead of using the general call.
This sequence is an editorial arrangement of the steps NIST lists; the page does not state eligibility rules or costs, so confirm those with NCNR staff directly.
Instrument types and review routes
NIST’s call-for-proposals page (updated 23 September 2026, read 13 November 2026) names the instruments that take proposals and sorts them by how the proposal is reviewed. Instruments are the practical unit of a neutron experiment: each one is built for a particular kind of measurement, so choosing the instrument is the first scientific decision a proposer makes. The page identifies some by technique, for example the NG7 30-m small-angle neutron scattering (SANS) instrument, the vSANS instrument, the BT1 powder diffractometer, the BT7 triple-axis spectrometer, the Disk-Chopper Spectrometer (DCS) and the Neutron Imaging Facility (NIF); technique details for each are on NIST’s instrument pages.
| Review route | Instruments named by NIST |
|---|---|
| Full external review plus Beam Time Allocation Committee (CHRNS instruments) | CANDOR, HFBS, MACS, ν-NSE, vSANS |
| Reviewed internally (other NIST instruments) | BT7, DCS, NG7 (30-m SANS), BT1 (mail-in only), Neutron Imaging Facility |
The same page says proposals are reviewed for scientific merit by experts external to the NCNR. One route is unusual: BT1 accepts mail-in powder diffraction proposals for relatively simple experiments that use only the room-temperature sample changer or closed-cycle refrigerators. For approved proposals the samples are mailed to NCNR staff, who collect the data, and up to 25 percent of BT1 beam time may go to mail-in proposals.
What a proposal contains
NIST requires an account on the NCNR Information Management System (NCNR-IMS) to submit. The experiment description is a PDF that may include high-resolution figures, with a limit of three letter-size pages including references and a file size of no more than 1.5 MB. NIST urges proposers to contact the appropriate instrument scientist well before the deadline, so that the proposal addresses the key review aspects and has achievable goals.
Call timing
The call page listed the most recent window as closed, running from 30 July 2026 to 15 September 2026 (midnight), with successful proposals expected to begin running in early January 2027, although some may start earlier. This is a dated snapshot; the next window will differ, so read the live page before planning.
Where it matters for labs and research offices
For a research office, the practical points are about planning and compliance rather than equipment. Beam time is awarded by peer review, so it is not something a project can assume at budget time; a grant application that depends on neutron measurements should describe the access route. Proprietary work follows a separate contact route from open academic proposals, so industry collaborators should not use the same path as a university group. Publications and participant counts reported by the facility are one way funders and institutions can see how the facility is used, but the counts are NIST’s own figures.
Related facilities with different operators and access rules are covered in the Spallation Neutron Source guide, the Advanced Photon Source guide and the Advanced Test Reactor guide. For neutron-based analysis done as a service rather than as a beam experiment, see neutron activation analysis.
Common misunderstandings
- It is not only for NIST scientists. NIST describes it as a user facility for all qualified applicants from academia, industry and government.
- It is not an accelerator source. The NCNR’s neutrons come from a reactor, the NBSR. The Spallation Neutron Source is a different kind of facility.
- The replacement reactor is not built. The NNS exists as a pre-conceptual design report, TN 2280.
- Banner figures are not constants. Instrument and publication counts are shown as displayed on the NCNR home page on the date read.
- Beam time is not bought or booked like a core-facility slot. The access page describes a peer-reviewed allocation process; scheduling by NCNR staff follows approval, not the other way round.
- One review route does not fit every instrument. According to the call page, some instruments go through external review and the Beam Time Allocation Committee while others are reviewed internally, so ask the instrument scientist which route applies to your measurement.
- A proposal is short. The experiment description is limited to three letter-size pages including references, so the case has to be made concisely and with the right instrument in mind.
FAQ
What is the NIST Center for Neutron Research?
A national user facility at NIST in Gaithersburg, Maryland, offering thermal and cold neutron beam instruments to qualified applicants from academia, industry and government.
How do I get beam time at the NCNR?
Submit a proposal. It is peer-reviewed by technical experts, the Beam Time Allocation Committee recommends instrument time, and staff schedule approved time. Proposals are called for approximately twice a year.
Is the NCNR reactor licensed?
Yes. NIST lists NRC License No. TR-5 (Docket 50-184), classified as a Research Reactor under License Amendment No. 17.
Is there a replacement reactor?
NIST Technical Note 2280 describes a pre-conceptual design for one, the NIST Neutron Source. It is a design study only.
How long can a proposal be?
The experiment description is a PDF of no more than three letter-size pages including references, and no larger than 1.5 MB (NIST call-for-proposals page, updated 23 September 2026).
Do I need an account to submit?
Yes. NIST requires an account on the NCNR Information Management System (NCNR-IMS) to submit a proposal.
Can samples be measured without visiting?
For the BT1 powder diffractometer, NIST accepts mail-in proposals for relatively simple experiments; staff collect the data on samples that are mailed in, and up to 25 percent of BT1 beam time may go to mail-in proposals.
Sources
- NIST, NIST Center for Neutron Research, read 13 November 2026.
- NIST, About the NCNR, updated 31 October 2024, read 13 November 2026.
- NIST, NCNR reactor overview, read 13 November 2026.
- NIST, Obtaining beam time, read 13 November 2026.
- NIST, Call for proposals, updated 23 September 2026, read 13 November 2026.
- Cook, Majkrzak, King and Neumann, NIST Technical Note 2280, approved 21 December 2023.
Data: Routes to NCNR instrument time as described on NIST's Obtaining Beam Time page
Compiled from the NIST Center for Neutron Research Obtaining Beam Time page; each row restates what that page says about one route to instrument time, its review step and where to start.
| Route | Where it starts | Review or allocation step | Example or note |
|---|---|---|---|
| General proposal | Researcher submits a proposal in a call (approximately twice a year) | Peer review by technical experts, then NCNR Beam Time Allocation Committee recommends time; staff schedule it | Open to qualified applicants from academia, industry and government |
| Staff collaboration | Contact an NCNR staff member to discuss ideas | Leads into a proposal | Page invites contact before proposing |
| Consortium instrument | Membership in the instrument's consortium | Consortium members are entitled to a portion of the time | NG7 30-m SANS; BT2 Imaging Facility |
| Proprietary access | Contact the relevant Team Leads | Not described on the page | For users seeking proprietary work |
Sources
- NIST Obtaining Beam Time (accessed 2026-11-13)
Compiled by CASRAI from the sources above. Free to reuse under CC BY 4.0 with attribution.







