Written and maintained by CASRAI Editorial Board
Published
This page describes products and general use; it is not medical advice.
On this page
A triple-lumen catheter is a catheter with three separate, non-communicating channels (lumens) in one catheter body. The most common form searched for is the triple-lumen central venous catheter (CVC), used in hospitals so that several infusions, sampling and pressure monitoring can share one vascular access site. Clinic staff, buyers and students use this page to see what the three lumens are, how sizes differ between products and which related device pages to read next.
What is a triple-lumen catheter?
“Triple lumen” describes the number of channels, not one specific device. Cook Medical’s instructions for use (IFU) for its central venous catheters say the polyurethane catheters “incorporate separate, non-communicating vascular access lumens within a single catheter body” (Cook IFU C_T_RDULM_REV4, read 2026-11-07). Because the lumens do not connect inside the catheter, different fluids can run through different lumens at the same time. The same IFU describes the catheters as designed for treatment of critically ill patients.
Who uses it: hospital clinicians (critical care and other controlled hospital settings) place and use these catheters; the IFU states that use should be limited to controlled hospital situations and that placement is performed by physicians trained in the Seldinger (wire-guided) technique. Purchasing and supply staff, nurses and students encounter the device by its lumen count and French size.
How a triple-lumen catheter is built
In the Cook central venous catheter IFU, the catheter body is polyurethane, and the device and its components are latex-free. Sets and trays also contain an access needle, a wire guide and accessories. The catheter is supplied sterilized by ethylene oxide gas in peel-open packages and is intended for one-time use. Heparin-coated versions exist (designated by a -BH suffix in the order number) for short-term protection against thrombus formation; the IFU states a history of heparin-induced thrombocytopenia is a reason not to use a heparin-coated catheter.
Each lumen opens at a different exit port along the catheter. In the Cook triple-lumen design the three exit ports are distal (an endhole at the tip), middle and proximal.
Types and variants
“Triple lumen” appears across several device families. They differ in where they are placed and how long they stay in, so check which one a document means before comparing specifications.
| Type | Typical use (as described by the source) | Key difference | Source |
|---|---|---|---|
| Short-term triple-lumen CVC (Cook uncoated and heparin-coated) | Drug infusions, central venous pressure monitoring, acute hyperalimentation, blood sampling, blood product delivery, simultaneous separate infusions | Non-tunneled, for controlled hospital situations; not for long-term indwelling use or chronic hyperalimentation | Cook IFU C_T_RDULM_REV4 |
| Tunneled triple-lumen TPN catheter (Cook 8.0T Fr) | Parenteral nutrition catheter set | Three separate lumens in one body, 90 cm length, with a synthetic fiber cuff and clamps | Cook IFU C_T_TPN_REV6 |
| Triple-lumen PICC | See the PICC guide | Inserted peripherally; compared with single- and double-lumen PICCs in our guide | Double-lumen PICC guide |
Specifications that matter: gauge and lumen volume
Lumen size is given as an equivalent gauge and a minimum lumen volume, and it differs by lumen and by catheter size. The table reproduces the triple-lumen rows of the Cook IFU; other manufacturers publish their own values.
| Catheter size | Lumen | Equivalent gauge | Minimum lumen volume |
|---|---|---|---|
| 7.0 Fr | #1 | 16 | 0.6 cc |
| 7.0 Fr | #2 | 18 | 0.5 cc |
| 7.0 Fr | #3 | 18 | 0.6 cc |
| 9.0 Fr | #1 | 14 | 0.9 cc |
| 9.0 Fr | #2 | 18 | 0.4 cc |
| 9.0 Fr | #3 | 18 | 0.5 cc |
Source: Cook Medical IFU C_T_RDULM_REV4, “Triple-Lumen Information”, read 2026-11-07. The tunneled 8.0T Fr triple-lumen set in IFU C_T_TPN_REV6 lists a small lumen of 0.029 in (1.2 mL) and a large lumen of 0.043 in (1.8 mL) at 90 cm, so sizes are not interchangeable between product families. The central venous catheter IFU also gives standard adult lengths of 15, 20, 25 and 30 cm for the 7.0 to 10.0 Fr range as a guideline only.
What each lumen is suggested for
The Cook IFU’s “Suggested Lumen Utilization: Triple-Lumen” assigns uses by exit port:
- Lumen #1, distal exit port (endhole): whole blood or blood product delivery and sampling, situations needing more flow, CVP monitoring and medication delivery. The IFU strongly recommends this lumen for all blood sampling.
- Lumen #2, middle exit port: medication delivery and acute hyperalimentation.
- Lumen #3, proximal exit port: medication delivery.
The IFU notes the catheter is not recommended for right atrial air aspiration because of inadequate sideport surface area. This is one manufacturer’s suggestion; a facility’s own protocol and the IFU of the product in hand govern.
How to choose: variables the IFU lists
The Cook IFU lists the factors that bear on selecting a central venous catheter: patient history, size and age of the patient, the access site available, unusual anatomical variables, and the proposed use and duration of the treatment plan. It states “the catheter size should be as small as the use will allow” and notes that larger-diameter catheters tend to promote clots. These are clinical selection criteria for the treating physician, not purchasing rules.
Regulatory classification
In the United States, intravascular catheters for short-term use (less than 30 days) to sample blood, monitor blood pressure or administer fluids are described in 21 CFR 880.5200 and are Class II (21 CFR 880.5200, Cornell LII, read 2026-11-07). The openFDA classification database lists product code FOZ (“Catheter, Intravascular, Therapeutic, Short-Term Less Than 30 Days”, class 2) and a separate code, LJS, for long-term (greater than 30 days) therapeutic catheters under 21 CFR 880.5970, also class 2 (openFDA, read 2026-11-07). For the voluntary consensus standard that covers catheter performance, see our ISO 11070 guide.
Safe use and handling basics
From the Cook IFU, in general terms:
- The catheter is for one-time use and must not be re-sterilized; it must not be cut, trimmed or modified.
- Do not power inject contrast medium through the catheter, because rupture may result. The IFU says a syringe of 10 mL or larger reduces risk.
- Tip position is verified by X-ray after placement.
- If flow in a lumen is impeded, do not force injection or withdrawal.
- Placement and use belong to trained clinicians in controlled hospital settings. For complication prevention, see antimicrobial catheters.
Common mistakes
- Treating “triple lumen” as one specification. Gauge, volume and length differ by size and product, as the tables above show.
- Mixing up device families. A triple-lumen CVC, a triple-lumen PICC and a three-way urinary catheter share a lumen count only; see central venous catheter, PICC line and catheter lumen.
- Assuming every lumen is equivalent. The IFU gives the larger distal lumen a different suggested role from the smaller lumens.
FAQ
Can you have a triple-lumen PICC?
Yes. Our double-lumen PICC guide compares single-, double- and triple-lumen PICC configurations from manufacturer instructions for use. Which is appropriate for a patient is a clinical decision.
Which catheter is best for dialysis?
This page does not rank catheters. Hemodialysis uses purpose-built dialysis catheters, which are a different device class from the infusion CVCs described above; the Cook CVC IFU does not cover dialysis use. See what a hemodialysis catheter is for that device.
What are the 3 main types of urinary catheters?
This page covers vascular catheters, so it does not rank urinary catheter types. For Foley-type urinary catheters, manufacturer labels use a way-count: a 2-way catheter has a drainage lumen and a balloon lumen, and a 3-way catheter adds an irrigation lumen. Our catheter lumen guide explains the labels; it is a different device from a vascular triple-lumen catheter.
What is the process of inserting a central venous catheter (CVC)?
Central venous catheters are placed by physicians trained in the Seldinger (wire-guided) technique, with the tip position confirmed by X-ray, per the manufacturer’s IFU. Step-by-step insertion instructions are clinical-procedure content and are not given here; use the product IFU and your facility’s protocol.
Sources
- Cook Medical, “Uncoated and Heparin-Coated Central Venous Catheters” IFU, C_T_RDULM_REV4, https://ifu.cookmedical.com/data/IFU_PDF/C_T_RDULM_REV4.PDF (read 2026-11-07).
- Cook Medical, “TPN Catheters and Sets” IFU, C_T_TPN_REV6, https://ifu.cookmedical.com/data/IFU_PDF/C_T_TPN_REV6.PDF (read 2026-11-07).
- 21 CFR 880.5200, Intravascular catheter, https://www.law.cornell.edu/cfr/text/21/880.5200 (read 2026-11-07).
- openFDA device classification API, product codes FOZ and LJS, https://api.fda.gov/device/classification.json (read 2026-11-07).







