Skip to main content
v2026.11,986 entries · CC-BY 4.0

Biofilm EPS: Extracellular Polymeric Substances, Components and Roles

Biofilm EPS (extracellular polymeric substances): matrix components, functions, enzyme sensitivity and extraction trade-offs from named sources.

Written and maintained by CASRAI Editorial Board

Published

On this page

Biofilm EPS are the extracellular polymeric substances that microbial cells produce and embed themselves in: a mixture of polysaccharides, proteins, extracellular DNA (eDNA) and lipids that, together with water, forms the biofilm matrix. The matrix holds cells together and to a surface, gives the biofilm its cohesion and viscoelasticity, and shields the community from antimicrobials and host immunity. Its make-up differs by species, strain, age and environment, which is why one matrix-degrading enzyme works on one biofilm and not on another.

Definition and scope: what biofilm EPS means

Di Martino (2018, AIMS Microbiology) describes extracellular polymeric substances as organic polymers of microbial origin that mediate the interactions of cells with their environment. In a biofilm they are the main non-cellular part of the matrix. The matrix itself is mostly water plus EPS, and the EPS fraction is mainly polysaccharides, proteins and DNA, with lipids also reported (detected, for example, by infrared spectroscopy). A 2013 special-issue editorial on the EPS matrix describes the same four classes (proteins, polysaccharides, nucleic acids and lipids) and calls the matrix a “built environment” that gives cells a protective layer and an architecture within which they interact and signal to each other.

The matrix is held together largely by weak, non-covalent bonds between its polymers. Di Martino ties this to the two mechanical properties that matter at the bench: cohesion (the biofilm stays in one piece) and viscoelasticity (it deforms and recovers under stress, rather than shearing off cleanly).

EPS biofilm, EPS biofilms, extracellular polymeric substances biofilm: one concept, several spellings

Searches such as “eps biofilm”, “eps biofilms”, “biofilm extracellular polymeric substances” and “extracellular polymeric substances biofilm” all point at the same thing: the polymer fraction of the biofilm matrix. Three neighbouring terms are easy to confuse with it:

  • Exopolysaccharide. Only the polysaccharide part of EPS (for example alginate, Psl, Pel or PNAG). Gong et al. (2024) treat exopolysaccharides, extracellular proteins and eDNA as the main EPS classes.
  • Biofilm matrix. The whole hydrated scaffold: EPS plus the water it holds. Cells are embedded in it but are not part of it.
  • eDNA. DNA found outside cells within the matrix. Once treated as a minor component, it is now described as structural (see below).

How the EPS matrix works in practice

The Center for Biofilm Engineering at Montana State University describes a biofilm as cells held together by a matrix of extracellular polymeric substances, and lays out a life cycle in which cells attach to a surface within minutes, the biofilm matures over hours, and cells later disperse either as clumps or as individual cells seeded out of the structure. The EPS matrix is present at each stage. The Center also states that cells in biofilms can tolerate antibiotic concentrations up to 1,000 times those that kill free-floating (planktonic) cells, and that natural biofilms are usually mixed-species communities.

Gong et al. (2024, Frontiers in Microbiology) group the documented functions of EPS into three roles: anchoring cells to surfaces and to each other, giving the community structural stability, and shielding it from antimicrobial agents and host immune responses. Their review organises the matrix components by organism, which is the practical point: there is no single “biofilm EPS” composition to look up. You have to know the organism.

Component classes and named examples

The data table below compiles, organism by organism, the best-characterised EPS components named in the sources. A few points from the table deserve explanation.

  • Pseudomonas aeruginosa makes three distinct exopolysaccharides. Alginate (mucoid strains) is high in molecular weight, negatively charged and acetylated. Psl is neutral and branched, forms a fibre network and supports attachment. Pel is cationic, rich in N-acetylglucosamine and N-acetylgalactosamine, and mediates cell-to-cell interaction.
  • eDNA is structural, not debris. Di Martino reports that eDNA promotes adherence to hydrophobic surfaces and cell aggregation, nucleates amyloid polymerisation, forms a fibre network with Psl and binds the cationic Pel in the P. aeruginosa biofilm stalk. In S. aureus it comes from autolysis of a subpopulation of sessile cells.
  • Amyloids are the main protein component of many biofilms. Curli, made by E. coli, are filamentous structures involved in adhesion and biofilm formation, and the major subunit CsgA contains repeat units that drive self-assembly. In S. aureus, phenol-soluble modulins (PSMs) form amyloid fibres in the presence of eDNA.
  • Some S. aureus strains build the matrix from PNAG (poly-N-acetylglucosamine), which sets up the enzyme-sensitivity differences discussed next.

Composition decides what degrades the matrix

This is the practical consequence of species-specific EPS. Di Martino summarises studies in which proteases, polysaccharidases and DNases were used to prevent biofilm formation or to detach existing biofilms, and states that they work “with various efficiencies, depending on bacterial species, bacterial strains, and biofilm age”. The examples below are all taken from that review.

Treatment Reported behaviour
Dispersin B (targets β-1,6-linked N-acetylglucosamine) Most efficient against S. aureus strains that produce large amounts of PNAG
Protease Works best on S. aureus strains that produce little or no PNAG; serine proteases were highly effective against several biofilms
α-Amylase More effective against P. aeruginosa than S. aureus
Cellulase Breaks P. aeruginosa pellicles into fragments
DNase I Prevented P. aeruginosa biofilm formation and dissolved young biofilms (12 to 60 h), with little effect on 84 h biofilms
EDTA combined with other agents Improved removal

The DNase result is the clearest evidence that the matrix changes with age: the same enzyme, on the same species, stops working as the biofilm matures. Di Martino also notes that infrared band ratios shift during growth, reflecting changes in polysaccharide, protein and nucleic acid content, and that temperature and ionic strength alter the rheology of P. aeruginosa EPS.

Where it matters for labs: characterising and extracting EPS

The 2013 editorial notes that EPS are hard to characterise beyond bulk properties, that analysis should ideally disturb the matrix as little as possible, that in situ probing is emphasised, and that much environmental EPS remains uncharacterised. Di Martino adds that different extraction methods recover different EPS fractions, so a number reported from one extraction is not directly comparable with a number from another.

One concrete comparison is Jachlewski et al. (2015, Frontiers in Bioengineering and Biotechnology), who tested five ways of isolating EPS from biofilms of the archaeon Sulfolobus acidocaldarius. It is a single study in a single organism, so treat it as an illustration of trade-offs rather than a universal ranking. The table summarises what the authors reported.

Method (as tested) What the authors reported
Shaking in phosphate buffer No loss of viability and the fewest protein spots on 2-DE (about 300), but it recovered less EPS
Cation-exchange resin (Dowex Marathon C) Judged best: high yield, no apparent cell lysis, no effect on later analysis, resin removed by centrifugation; it removed Ca²⁺ and Mg²⁺
EDTA (2%) Interfered with the Lowry protein assay by chelating copper; no 2-DE separation could be achieved
Crown ether (30 mM) Reduced culturability and interfered with the carbohydrate assay, giving values the authors considered unrealistic
NaOH (1 M) pH rose to about 13.3, cell counts fell below detection and culturability was lost, attributed to cell lysis; the chemical stayed in the sample and required dialysis

The same paper quantified the extracted material with the phenol-sulfuric acid method for carbohydrates (glucose standard), a modified Lowry assay for protein (bovine serum albumin standard) and a PicoGreen fluorometric kit for DNA. The lesson that carries over is that the extraction chemistry and the downstream assay have to be chosen together: a reagent that releases EPS cleanly can still break the assay you planned to run on it, and a harsh reagent can lyse cells so that intracellular material is counted as EPS.

For laboratories that work with biofilms in water systems, wound or device models, or contaminated process lines, the matrix is the reason cleaning claims need care. See the CASRAI guides on sulfate-reducing bacteria, which form biofilms in industrial settings, and on enzymatic cleaners, which target matrix polymers, as well as endoscope reprocessing and bacteriological water testing for settings where surface-attached growth is a practical concern.

Common misunderstandings

  • “EPS means sugar.” The abbreviation originally pointed at polysaccharides, but the sources describe proteins, eDNA and lipids as part of the matrix, and amyloid proteins as the main proteinaceous component of many biofilms.
  • “The matrix is the same in every biofilm.” Gong et al. list the matrix components species by species, and Di Martino shows enzymes that work on PNAG-rich S. aureus but not on protease-sensitive, PNAG-poor strains.
  • “Biofilm cells are just bacteria stuck on a surface.” The Center for Biofilm Engineering describes a structured community with attachment, maturation and dispersal stages, usually containing more than one species.
  • “Any extraction recovers all the EPS.” Different methods recover different fractions, and harsher ones can lyse cells or leave reagent behind.
  • “A biofilm EPS result transfers across organisms.” Composition, age and conditions all shift the matrix, so a protocol validated on one organism is evidence, not proof, for another.

For the neighbouring concept of resistant bacterial forms, see formation of spores in bacteria, and for the wider discipline, what is bacteriology. This page describes concepts and published findings, not laboratory procedures or advice for any individual case.

Sources

Data: Named EPS components of bacterial biofilm matrices by class, organism and documented property

Original compilation of the best-characterised extracellular polymeric substance (EPS) components named in two review articles on biofilm matrices, arranged by component, class and producing organism, with the property or role each source reports. Only values stated in the listed sources are included; no composition percentages are given because the sources do not provide comparable ones.

Named EPS components of bacterial biofilm matrices by class, organism and documented property
EPS componentClassOrganismDocumented property or role
AlginateExopolysaccharidePseudomonas aeruginosa (mucoid strains)High molecular weight, negatively charged, acetylated
PslExopolysaccharidePseudomonas aeruginosaNeutral, branched; forms a fibre network that promotes attachment; forms fibres with eDNA
PelExopolysaccharidePseudomonas aeruginosaCationic, rich in GlcNAc and GalNAc; mediates cell-cell interaction; binds and cross-links eDNA
Colanic acidExopolysaccharideEscherichia coliNamed as an E. coli matrix exopolysaccharide
PNAG (poly-N-acetylglucosamine)ExopolysaccharideStaphylococcus aureus (some strains)Strains making much PNAG are most susceptible to dispersin B; protease works best on strains making little or none
Curli (CsgA subunit)Amyloid proteinEscherichia coliFilamentous; involved in adhesion and biofilm formation; CsgA repeat units drive self-assembly
Phenol-soluble modulins (PSMs)Amyloid proteinStaphylococcus aureusForm amyloid fibres in interaction with eDNA
eDNAExtracellular DNAP. aeruginosa and S. aureusPromotes adherence to hydrophobic surfaces and aggregation; nucleates amyloid polymerisation; in S. aureus released by autolysis of a subpopulation

Sources

Compiled by CASRAI from the sources above. Free to reuse under CC BY 4.0 with attribution.

Follow CASRAI

Research-administration guidance, standards updates and independent tool reviews.

Ask CASRAI · free to try

Ask about Biofilm EPS: Extracellular Polymeric Substances, Components and Roles

2 free questions a day, no account.

An AI assistant for research: funder rules, compliance, methods and publishing. It links the sources behind its answers and labels answers that come from a web search.

Answers draw on CASRAI's guides and dictionary plus the federal and funder documents we index: Federal Register, Grants.gov, Regulations.gov and UKRI.

Works on this site and inside Claude, Cursor and the AI tools you already use.

Everything CASRAI publishes — this page, the dictionary, the guides and the news — stays open to read, with no account and no card.

Referenced across the research world

University of Cambridge logoColumbia University logoCrossref logoUniversity of Edinburgh logoHarvard University logoUniversity of Oxford logoPrinceton University logoStanford School of Medicine logoUniversity College London logoORCID logoUniversity of Cambridge logoColumbia University logoCrossref logoUniversity of Edinburgh logoHarvard University logoUniversity of Oxford logoPrinceton University logoStanford School of Medicine logoUniversity College London logoORCID logo
  • University of Cambridge logo
  • Columbia University logo
  • Crossref logo
  • University of Edinburgh logo
  • Harvard University logo
  • University of Oxford logo
  • Princeton University logo
  • Stanford School of Medicine logo
  • University College London logo
  • ORCID logo

View CASRAI adoption →